Configuring the Switch
3-98
CLI – This example configures a static source-guard binding on port 5.
Dynamic IP Source Guard Binding Information
Use the Dynamic Information page to display the source-guard binding table for a
selected interface.
Command Attributes
• Query by – Select an interface to display the source-guard binding. (Options: Port,
VLAN, MAC Address, or IP Address)
• Dynamic Binding Table Counts – Displays the number of IP addresses in the
source-guard binding table.
• Current Dynamic Binding Table – Displays the IP addresses in the source-guard
binding table.
Web – Click IP Source Guard, Dynamic Information.
Figure 3-53 Dynamic IP Source Guard Binding Information
CLI – This example displays all IP source-guard bindings.
Console(config)#ip source-guard binding 11-22-33-44-55-66 vlan 1
192.168.0.99 interface ethernet 1/5 4-114
Console(config)#
Console#show ip source-guard binding 4-114
MacAddress IpAddress Lease(sec) Type VLAN
Interface
----------------- --------------- ---------- -------------------- ---- ----
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#
To Next Page
Loading...
Need help?
General