Simple Network Management Protocol
3-43
Configuring SNMPv3 Management Access
To configure SNMPv3 management access to the switch, follow these steps:
1. If you want to change the default engine ID, it must be changed first before
configuring other parameters.
2. Specify read and write access views for the switch MIB tree.
3. Configure SNMP user groups with the required security model (i.e., SNMP v1,
v2c or v3) and security level (i.e., authentication and privacy).
4. Assign SNMP users to groups, along with their specific authentication and
privacy passwords.
Setting the Local Engine ID
An SNMPv3 engine is an independent SNMP agent that resides on the switch. This
engine protects against message replay, delay, and redirection. The engine ID is
also used in combination with user passwords to generate the security keys for
authenticating and encrypting SNMPv3 packets.
A local engine ID is automatically generated that is unique to the switch. This is
referred to as the default engine ID. If the local engine ID is deleted or changed, all
SNMP users will be cleared. You will need to reconfigure all existing users.
A new engine ID can be specified by entering 1 to 26 hexadecimal characters. If less
than 26 characters are specified, trailing zeroes are added to the value. For
example, the value “1234” is equivalent to “1234” followed by 22 zeroes.
Web – Click SNMP, SNMPv3, Engine ID. Enter an ID of up to 26 hexadecimal
characters and then click Save.
Figure 3-24 Setting an Engine ID
CLI – This example sets an SNMPv3 engine ID.
Console(config)#snmp-server engine-id local 12345abcdef 4-67
Console(config)#exit
Console#show snmp engine-id 4-68
Local SNMP engineID: 12345abcdef000000000000000
Local SNMP engineBoots: 1
Console#
To Next Page
Loading...
Need help?
General