Edge-Core ES4524M-POE

Port Configuration
3-119
Web – Click Port, Port Broadcast Control or Trunk Broadcast Control. Set the
threshold for each port, click Apply.
Figure 3-62 Port Broadcast Control
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 500
packets per second for port 2.
Console(config)#interface ethernet 1/1 4-135
Console(config-if)#no switchport packet-rate 4-141
Console(config-if)#exit
Console(config)#broadcast packet-rate 64000 4-141
Console(config)#exit
Console#show interfaces switchport ethernet 1/2 4-145
Information of Eth 1/2
Broadcast Threshold: Enabled, 64000 Kbits/second
Multicast Threshold: Disabled
Unknown-unicast Threshold: Disabled
LACP Status: Disabled
Ingress Rate Limit: Disabled, 1000000 Kbits per second
Egress Rate Limit: Disabled, 1000000 Kbits per second
VLAN Membership Mode: Hybrid
Ingress Rule: Enabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),4093(t),
Forbidden VLAN:
Private-VLAN Mode: NONE
Private-VLAN host-association: NONE
Private-VLAN Mapping: NONE
Console#