Power over Ethernet Commands
4-165
4
show power mainpower
Use this command to display the current power status for the switch.
Command Mode
Privileged Exec
Example
Table 4-12 show power inline status parameters
Parameter Description
Admin The power mode set on the port (see power inline on page 4-162)
Oper The current operating power status (displays on or off)
Power (mWatt) The maximum power allocated to this port (see power inline maximum
allocation on page 4-163)
Power (used) The current power consumption on the port in milliwatts
Priority The port’s power priority setting (see power inline priority on page 4-163)
Console#show power mainpower
Unit 1 Mainpower Status
Maximum Available Power : 180 watts
System Operation Status : on
Mainpower Consumption : 15 watts
Software Version : Version 0x0122, Build 0x15
Console#
Table 4-13 show power mainpower parameters
Parameter Description
Maximum Available Power The available power budget for the switch (see power mainpower maximum
allocation on page 4-160)
System Operation Status The current operating power status (displays on or off)
Mainpower Consumption The current power consumption on the switch in watts
Software Version The version of software running on the PoE controller subsystem in the switch.