Command Line Interface
4-10
4
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration) LC (Line Configuration)
CM (Class Map Configuration) MST (Multiple Spanning Tree)
NE (Normal Exec) PE (Privileged Exec)
GC (Global Configuration) PM (Policy Map Configuration)
IC (Interface Configuration) VC (VLAN Database Configuration)
General Commands
These commands are used to control the command access mode, configuration
mode, and other basic functions.
enable
This command activates Privileged Exec mode. In privileged mode, additional
commands are available, and certain commands display additional information.
(See “Understanding Command Modes” on page 4-6.)
Syntax
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
Default Setting
Level 15
Table 4-5 General Commands
Command Function Mode Page
enable Activates privileged mode NE 4-10
disable Returns to normal mode from privileged mode PE 4-11
configure Activates global configuration mode PE 4-12
show history Shows the command history buffer NE, PE 4-12
reload Restarts the system PE 4-13
prompt Customizes the prompt used in PE and NE mode GC 4-13
end Returns to Privileged Exec mode any
config.
mode
4-14
exit Returns to the previous configuration mode, or exits the CLI any 4-14
quit Exits a CLI session NE, PE 4-14
help Shows how to use help any NA
? Shows options for command completion (context sensitive) any NA
To Next Page
Loading...
Need help?
General