LLDP Commands
4-227
4
lldp medtlv extpoe
This command configures an LLDP-MED-enabled port to advertise and accept
Extended Power-over-Ethernet configuration and usage information. Use the no
form to disable this feature.
Syntax
[no] lldp medtlv extpoe
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises extended Power-over-Ethernet capability details, such
as power availability from the switch, and power state of the switch, including
whether the switch is operating from primary or backup power (the Endpoint
Device could use this information to decide to enter power conservation
mode). Note that this device does not support PoE capabilities.
Example
lldp medtlv inventory
This command configures an LLDP-MED-enabled port to advertise its inventory
identification details. Use the no form to disable this feature.
Syntax
[no] lldp medtlv inventory
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises device details useful for inventory management, such
as manufacturer, model, software version and other pertinent information.
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp medtlv extpoe
Console(config-if)#
To Next Page
Loading...
