EasyManuals Logo

Edge-Core ES4524M-POE User Manual

Edge-Core ES4524M-POE
560 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
Initial Configuration
2-4
2
Setting Passwords
Note: If this is your first time to log into the CLI program, you should define new
passwords for both default user names using the “username” command, record
them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case sensitive.
To prevent unauthorized access to the switch, set the passwords as follows:
1. Open the console interface with the default user name and password “admin” to
access the Privileged Exec level.
2. Type “configure” and press <Enter>.
3. Type “username guest password 0 password,” for the Normal Exec level, where
password is your new password. Press <Enter>.
4. Type “username admin password 0 password,” for the Privileged Exec level,
where password is your new password. Press <Enter>.
Setting an IP Address
You must establish IP address information for the switch to obtain management
access through the network. This can be done in either of the following ways:
Manual — You have to input the information, including IP address and subnet mask.
If your management station is not in the same IP subnet as the switch, you will also
need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or DHCP
address allocation servers on the network.
Manual Configuration
You can manually assign an IP address to the switch. You may also need to specify
a default gateway that resides between this device and management stations on
another network segment. Valid IP addresses consist of four decimal numbers, 0 to
255, separated by periods. Anything outside this format will not be accepted by the
CLI program.
Note: The IP address for this switch is obtained via DHCP by default.
Username: admin
Password:
CLI session with the ES4524M-PoE is opened.
To end the CLI session, enter [Exit].
Console#configure 4-12
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#

Table of Contents

Other manuals for Edge-Core ES4524M-POE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ES4524M-POE and is the answer not in the manual?

Edge-Core ES4524M-POE Specifications

General IconGeneral
BrandEdge-Core
ModelES4524M-POE
CategorySwitch
LanguageEnglish

Related product manuals