Edge-Core ES4524M-POE - Lldp Reinit-Delay; Lldp Tx-Delay

LLDP Commands
4-217
4
lldp reinit-delay
This command configures the delay before attempting to re-initialize after LLDP
ports are disabled or the link goes down. Use the no form to restore the default
setting.
Syntax
lldp reinit-delay <seconds>
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP.
(Range: 1 - 10 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
When LLDP is re-initialized on a port, all information in the remote systems
LLDP MIB associated with this port is deleted.
Example
lldp tx-delay
This command configures a delay time between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the no form
to restore the default setting.
Syntax
lldp tx-delay seconds
no lldp tx-delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
• The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
Console(config)#lldp reinit-delay 10
Console(config)#