Command Line Interface
4-222
4
lldp basic-tlv system-description
This command configures an LLDP-enabled port to advertise the system
description. Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv system-description
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The system description is taken from the sysDescr object in RFC 3418, which
includes the full name and version identification of the system's hardware type,
software operating system, and networking software.
Example
lldp basic-tlv system-name
This command configures an LLDP-enabled port to advertise the system name. Use
the no form to disable this feature.
Syntax
[no] lldp basic-tlv system-name
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The system name is taken from the sysName object in RFC 3418, which
contains the system’s administratively assigned name, and is in turn based on
the hostname command (page 56).
Example
Console(config)#interface eth 1/1
Console(config-if)#lldp basic-tlv system-description
Console(config-if)#
Console(config)#interface eth 1/1
Console(config-if)#lldp basic-tlv system-name
Console(config-if)#
To Next Page
Loading...
Need help?
General