Edge-Core ES4524M-POE

LLDP Commands
4-225
4
lldp dot3-tlv link-agg
This command configures an LLDP-enabled port to advertise its link aggregation
capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv link-agg
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the
link, and the 802.3 aggregated port identifier if this interface is currently a link
aggregation member.
Example
lldp dot3-tlv mac-phy
This command configures an LLDP-enabled port to advertise its MAC and physical
layer capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv mac-phy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises MAC/PHY configuration/status which includes
information about auto-negotiation capabilities, port speed, and duplex mode.
Example
Console(config)#interface eth 1/1
Console(config-if)#lldp dot3-tlv link-agg
Console(config-if)#
Console(config)#interface eth 1/1
Console(config-if)#lldp dot3-tlv mac-phy
Console(config-if)#