b. Press F3 Show Numbers to show numbers instead of bar graphs for the status of
the battery and temperature for the laser and sensor.
c.
Press F5 Increase Sample Rate to increase the current sample rate or press F6
Decrease Sample Rate to decrease the current sample rate.
The sample rate can be from 1 to 25.
d. If the alignment method for horizontal alignment is Manual 4 Point, press ALT >
Hide Angle to remove angular readings from the display.
7.2.8 Change the laser and sensor placement
Change the laser and sensor placement on the analyzer to reflect your current laser and
sensor setup.
Procedure
1. Activate an alignment job.
2. From the Laser Align Application main menu, press ALT > F8 Head Config.
3. Press F2 Toggle Head Config to select where to position the laser and sensor (left or
right for horizontal alignment jobs and straightness measurements, and up or down
for vertical alignment jobs).
For horizontal alignment, you can change the placement of the laser and sensor only
in Advanced mode.
4. Press Enter.
7.2.9 Charge the laser or sensor
1. Remove the cover from charger socket on the laser or sensor.
2.
Insert the charger into the charger socket of the laser or sensor and plug the other
end to a power outlet.
laser/sensor chargerFigure 7-14:
Advanced Laser Alignment
MHM-97432 Rev 7 181
To Next Page
Loading...
Need help?
General
