Emerson CSI 2140

5. Press F3 Recall Setup.
Rename an acquisition parameter setup in ODS/Modal
1.
From the ODS/Modal main menu, press F8 Job Manager.
2. Press F4 Edit This Job > F8 Analysis Setup > F6 Save / Recall Setup.
3. Use the up and down arrow keys to select a setup.
4. Press F4 Edit Setup Desc.
5. Enter up to 20 characters for a name.
6. Press Enter.
Reset the acquisition parameters to default values in ODS/
Modal
1. From the ODS/Modal main menu, press F8 Job Manager.
2. Press F4 Edit This Job > F8 Analysis Setup > F6 Save / Recall Setup.
3. Press F5 Recall Default Setup.
9.6.4 Save waveform data with ODS/Modal data
The time waveforms are not required for ODS/Modal jobs, but you can store them for
reference.
Procedure
1. Activate a job.
2. From the ODS/Modal main menu, press F8 Job Manager.
3. Use the up and down arrow keys to select a job.
4. Press F4 Edit This Job > F9 Save Waveforms.
9.6.5 Set the fixed reference sensor parameters in ODS/Modal
You cannot change these parameters after you collected data for the job.
Procedure
1. From the ODS/Modal main menu, press F8 Job Manager.
2. Use the up and down arrow keys to select a job.
3. Press F4 Edit This Job > F10 Set Fixed Reference Params.
4. Set the following options as necessary.
ODS/Modal
290 MHM-97432 Rev 7