Option Description
F4 Set Host
Name
Enter the host name of your computer. This computer should be on your
network and it should have AMS Machinery Manager installed. This value
must match what is set in AMS Machinery Manager for the Setup Options.
If your network includes a DHCP server (DHCP enabled), enter the
computer name. Otherwise, enter the IP Address of the computer. For
additional text tools, press the ALT key and different set of characters
appears.
F5 Set IP
Address
Enter the IP address of the host computer.
F6 Set Host Port Enter the TCP/IP port number to use to establish communication between
the analyzer and the host computer. This value must match what is set in
AMS Machinery Manager for the Setup Options. Use the default value
(10077) unless otherwise directed by technical support.
8. Press Enter.
9.
On the analyzer, open a program and select Connect For Transfer using a path below.
Choose the program that corresponds to the file type you want to transfer.
Program Key sequence to Connect for Transfer option
Analyze Home > F7 Analyze > ALT > F9 Connect For Transfer
Balance Home > F9 Balance > F12 Job Manager > F7 Connect For Transfer
ODS/Modal Home > F12 ODS/Modal > F8 Job Manager > F7 Connect For Transfer
Program Manager Home > F6 Program Manager > F8 Connect For Transfer
Route Home > F8 Route > ALT > F9 Route Mgnt > F7 Connect For Transfer
Laser Alignment Home > F10 Adv. Laser Align > ALT > F9 Job Manager > F7 Connect For
Transfer
Transient Home > F11 Adv. Transient > F8 Job Manager > F7 Connect For Transfer
Note
If you experience issues when trying to connect, press the F9 IP/release/renew option to reset
the DHCP process.
Both the analyzer and AMS Machinery Manager display a message indicating the
connection was made. You can now transfer files between the opened program and
AMS Machinery Manager.
Manually add a wireless network
You can manually set up a wireless network in the analyzer without being in range of the
wireless signal. You can then connect to the network when your analyzer is within range.
You may also need to manually set up a network if your analyzer does not see the network.
Transfer files with CSI 2140
MHM-97432 Rev 7 55
To Next Page
Loading...
Need help?
General
