• Do not share passwords, passcodes, or other protected information.
• Do not share the admin passcode.
1.3.4 Secure product disposal guidelines
Instructions for product removal
When the device needs to be disposed of, consider the following aspects of device removal:
• Identify whether the device can be reused in another part of the process for either testing or training
purposes.
• Identify what data is stored on the device and sanitize this data using your organization's security policy.
Consider restoring your factory configuration (see Restore the factory configuration).
— Verify that the local display passcode is set to the default “AAAA".
• If the device is ready for disposal, then it can be discarded or physically destroyed using your organization’s
security policy.
1.4 Related documentation
You can find all product documentation on the product documentation DVD shipped with the product or at
Emerson.com.
See any of the following documents for more information:
• Micro Motion 1600 Transmitters Product Data Sheet
• Micro Motion 1600 Transmitters with Configurable Inputs and Outputs: Configuration and Use Manual
• Replacing the Electronics Assembly Module for the 1600 Transmitter
• Sensor installation manual
1.5 Communication methods
You can use several different communications methods to interface with the transmitter. You may use
different methods in different locations or for different tasks.
Interface
Tool
Display Capacitive touch buttons
Universal Service Port ProLink
™
III
Modbus
®
over RS485 Port
(1)
Field Communicator HART
®
/Bell 202
(2)
(1) Modbus over RS 485 port only compatible with units sold with hardware board code M.
(2) Field communicator only compatible with units sold with hardware board code A.
For information about how to use the communication tools, see the appendices in this manual.
Before you begin Configuration and Use Manual
May2024 MS-00809-0200-1600
10 Emerson.com
To Next Page
Loading...
