Emerson Micro Motion 1600 - 2.3 Commissioning wizards; 2.4 Make a startup connection to the transmitter; 2.5 Set the transmitter clock

Table 2-1: Status LED and device status (continued)
Status LED condition Device status
Status LED off Transmitter is not receiving power.
Display is not seated or not functioning properly.
2.3 Commissioning wizards
The transmitter menu includes a Guided Setup to help you move quickly through the most common
configuration parameters. ProLink III
™
also provides a commissioning wizard.
By default, when the transmitter starts up, the Guided Setup menu is offered. You can choose to use it or not.
You can also choose whether or not Guided Setup is displayed automatically.
• To enter Guided Setup:
— During transmitter setup, choose Yes at the prompt.
— After transmitter setup, Menu → Startup Tasks
• To control the automatic display of Guided Setup, choose Menu → Configuration → Guided Setup.
For information on the ProLink III commissioning wizard, see the Micro Motion ProLink III with ProcessViz
Software User Manual.
As the commissioning wizards are self guided, they are not documented in detail.
2.4 Make a startup connection to the transmitter
For all configuration tools except the display, you must have an active connection to the transmitter to
configure the transmitter.
Procedure
Identify the connection type to use, and follow the instructions for that connection type in the appropriate
appendix.
Communications tool
Connection type to use Instructions
ProLink III
™
Service port Using ProLinkIII with the transmitter
Field communicator HART Using a field communicator with the
transmitter
2.5 Set the transmitter clock
Display
Menu → Configuration → Time/Date/Tag
ProLink III Device Tools → Configuration → Transmitter Clock
Field communicator Device Settings → Setup Overview → Real Time Clock
The transmitter clock provides timestamp data for alerts, service logs, history logs, and all other timers and
dates in the system. You can set the clock for your local time or for any standard time you want to use.
Note
You may find it convenient to set all of your transmitter clocks to the same time, even if the transmitters are in
different time zones.
To aid in record keeping convenience, set transmitter clocks located in different time zones to the same time.
Quick start Configuration and Use Manual
May2024 MS-00809-0200-1600
12 Emerson.com