Emerson Micro Motion 1600 - 7.2.5 Alerts, conditions, and configuration options; Configuration Error; Core Low Power; Configuration Warning

Procedure
Set Fault Timeout as desired.
• Default: 0 seconds
• Range: 0 to 60 seconds
If you set Fault Timeout to 0, fault actions are performed as soon as the alert condition is detected.
7.2.5 Alerts, conditions, and configuration options
For more information on these alerts, see Status alerts, causes, and recommendations.
Configuration Error
Default severity: Failure
Severity configurable: No
Fault Timeout applicable: No
Table 7-2: Configuration Error conditions
Name Ignorable
[020] Calibration Factors Missing No
[021] Incorrect Sensor Type Yes
[030] Incorrect Board Type No
Core Processor Update Failed Yes
Password Not Set No
Time Not Entered Yes
Batcher Not Configured Yes
[120] Curve Fit Failure (Concentration) No
Core Low Power
Default severity: Failure
Severity configurable: No
Fault Timeout applicable: No
Table 7-3: Core Low Power conditions
Name Ignorable
[031] Low Power No
Configuration Warning
Default severity: Maintenance Required
Severity configurable: Yes
Fault Timeout applicable: No
Table 7-4: Configuration Warning conditions
Name Ignorable
No Permanent License No
Clock Failure No
Configure device options and preferences Configuration and Use Manual
May2024 MS-00809-0200-1600
92 Emerson.com