Emerson Micro Motion 1600 - 7.2 Configure the transmitter response to alerts; 7.2.1 Configure the transmitter response to alerts using the display

Default = Disable
4. Enable or disable Start/Stop Inventory, as desired.
Default = Disable
5. If required, configure the totalizer/inventory control context menu password.
Option Description
No password
(default)
Start, stop or reset totalizer/inventory actions via the context menu do not
require a password.
Password Required When a user selects Start/Stop or Reset from the context menu and the
password is enabled for totalizer/inventory control, the user is required to enter
a password before the action occurs.
If the context menu password option has been set to Password Required, you will be prompted to enter
the password.
• Default: AAAA
• Range: Any four alphanumeric characters
• The display Password Required must be set to At Write or Enter Menu to enable the totalizer/
inventory control context menu password option.
Important
If you enable Password Required for totalizers and inventories, but you do not change the password
from the default, the transmitter will post a configuration alert.
7.2 Configure the transmitter response to alerts
7.2.1 Configure the transmitter response to alerts using the display
For some alerts, you can change the transmitter response to an alert by setting the alert severity. You can also
configure the transmitter to ignore some alerts and conditions.
The transmitter implements the NAMUR NE 107 specification for alerts. NAMUR NE 107 categorizes alerts by
the suggested operator action, not by cause or symptom. Each alert has one or more associated conditions.
Important
The transmitter reports all the process and device conditions that were reported by previous transmitters.
However, the transmitter does not report them as individual alerts. Instead, the transmitter reports them as
conditions associated with alerts.
Procedure
• To change the severity of an alert:
a) Choose Menu → Configuration → Alert Setup → Response to Alerts.
b) Select the alert.
c) Set Alert Severity as desired.
Configure device options and preferences Configuration and Use Manual
May2024 MS-00809-0200-1600
88 Emerson.com