Emerson Micro Motion 1600 - 2.6 View the licensed features (optional); 2.7 Set informational parameters

Procedure
1. Select the time zone that you want to use.
2. If you need a custom time zone, select Special Time Zone and enter your time zone as a difference from
UTC (Coordinated Universal Time).
3. Set the time appropriately.
Note
The transmitter does not adjust for Daylight Savings Time. If you observe Daylight Savings Time, you
must reset the transmitter clock manually.
4. Set the month, day, and year.
The transmitter tracks the year and automatically adds a day for leap years.
2.6 View the licensed features (optional)
Display
Menu → About → Licenses → Licensed Features
ProLink III Device Tools → Device Information → Licensed Features
Field communicator Device Settings → Device Information → Licenses
You can view the licensed features to ensure that the transmitter was ordered with the required features.
The transmitter license controls the features that are enabled on the transmitter, including both software
applications and I/O channels.
Licensed features are purchased and available for permanent use. The options model code represents the
licensed features.
A trial license allows you to explore features before purchasing. The trial license enables the specified features
for a limited number of days. This number is displayed for reference. At the end of this period, the feature will
no longer be available.
To purchase additional features or request a trial license, either write down or record the Unique ID Number
and current license key from your transmitter and then contact customer service. To enable the additional
features or trial license, you will need to install the new license on the transmitter.
2.7 Set informational parameters
Display
Menu → Configuration → Device Information
ProLink III Device Tools → Configuration → Informational Parameters
Field communicator Device Settings → Device Information
You can set several parameters that identify or describe the transmitter and sensor. These parameters are not
used in processing and are not required.
Procedure
1. Set informational parameters for the transmitter.
a) Set Transmitter Serial Number to the serial number of your transmitter.
The transmitter serial number is provided on the metal tag that is attached to the transmitter
housing.
b) Set Descriptor to any desired description of this transmitter or measurement point.
Configuration and Use Manual Quick start
MS-00809-0200-1600 May2024
Configuration and Use Manual 13