b) Select On my computer in 1600 device file format and click Next.
c) Select Save.
d) Browse to the desired location, then enter the name for this configuration file.
e) Set the file type.
— To save a backup file, set the file type to Backup.
— To save a replication file, set the file type to Transfer.
f) Select Save.
The configuration file is saved to the specified location as yourname.spare or yourname.xfer.
• To save the current configuration to your PC, in ProLink III format:
a) Choose Device Tools → Configuration Transfer → Save Configuration.
b) Select On my computer in ProLink III file format and click Next.
c) Select Save.
d) Select the configuration parameters to be included in this file.
— To save a backup file, select all parameters.
— To save a replication file, select all parameters except device-specific parameters.
e) Select Save.
f) Browse to the desired location, then enter the name for this configuration file.
g) Set the file type to ProLink configuration file.
h) Select Start Save.
The configuration file is saved to the specified location as yourname.pcfg.
3.2.3 Load a configuration file using the display
Prerequisites
You must have a backup file or a replication file available for use in internal memory.
Procedure
• To load a configuration file to the transmitter's internal memory:
a) Ensure the configuration file is in the Config folder.
b) Upload the configuration file through the USP file by specifying Device Tools → Configuration
Transfer → Load Configuration.
c) When prompted to load 1600 device configuration data from a file, click the on my 1600 device
internal memory radio button.
d) Choose Backup and click Restore.
The configuration file is loaded to internal memory as yourname.spare.
Introduction to configuration and commissioning Configuration and Use Manual
May2024 MS-00809-0200-1600
24 Emerson.com
To Next Page
Loading...
