Chapter 7 Configure device options and preferences.......................................................................... 83
7.1 Configure the transmitter display...........................................................................................83
7.2 Configure the transmitter response to alerts........................................................................88
Chapter 8 Integrate the meter with the control system..................................................................... 97
8.1 Channel configuration.............................................................................................................. 97
8.2 Configure I/O Channel A.......................................................................................................... 97
8.3 Configure I/O Channel B.......................................................................................................... 97
8.4 Configure an mA Output.......................................................................................................... 98
8.5 Configure a Frequency Output..............................................................................................106
8.6 Configure a Discrete Output..................................................................................................110
Chapter 9 Configure digital communications..................................................................................... 113
9.1 Configure HART
®
communications....................................................................................... 113
9.2 Configure Modbus communications.................................................................................... 117
Chapter 10 Complete the configuration................................................................................................ 121
10.1 Test or tune the system using sensor simulation.............................................................121
10.2 Enable or disable write-protection......................................................................................122
Chapter 11 Transmitter operation..........................................................................................................125
11.1 View process and diagnostic variables...............................................................................125
11.2 View and acknowledge status alerts.................................................................................. 126
11.3 Read totalizer and inventory values................................................................................... 127
11.4 Start, stop, and reset totalizers and inventories...............................................................127
Chapter 12 Operation using the batcher............................................................................................... 131
12.1 Run a batch............................................................................................................................ 131
12.2 Perform AOC calibration...................................................................................................... 134
Chapter 13 Measurement support..........................................................................................................137
13.1 Use Smart Meter Verification.............................................................................................. 137
13.2 Advanced Phase Measurement software.......................................................................... 145
13.3 Zero the meter.......................................................................................................................146
13.4 Set up pressure compensation........................................................................................... 148
13.5 Validate the meter................................................................................................................ 152
13.6 Perform a (standard) D1 and D2 density calibration........................................................154
13.7 Adjust concentration measurement with Trim Offset .....................................................156
13.8 Adjust concentration measurement with Trim Slope and Trim Offset ......................... 157
Chapter 14 Maintenance..........................................................................................................................161
14.1 Install a new transmitter license.........................................................................................161
14.2 Upgrade the transmitter firmware..................................................................................... 162
14.3 Reboot the transmitter.........................................................................................................163
14.4 Battery replacement............................................................................................................. 163
Chapter 15 Log files, history files, and service files..............................................................................165
15.1 Generate history files........................................................................................................... 165
15.2 Generate service files........................................................................................................... 170
Chapter 16 Troubleshooting.................................................................................................................... 177
16.1 Status LED and device status...............................................................................................177
Contents Configuration and Use Manual
May2024 MS-00809-0200-1600
4 Emerson.com
To Next Page
Loading...
