Values:
Off
Does not show the alert message when the toner is low.
On
*
Shows the alert message when the toner is low.
*
Factory default menu setting
Power On Wizard
Purpose:
To perform initial settings for the printer.
See Also:
“Setting Initial Settings on the Operator Panel” on page 29
Values:
Yes
Performs the initial settings for the printer.
No
*
Does not perform the initial settings for the printer.
*
Factory default menu setting
Maintenance
Use the Maintenance menu to adjust print settings for each paper type, initialize the Non-Volatile
Memory (NVM), and change the toner cartridge settings.
F/W Version
Purpose:
To display the version of the controller.
Adjust BTR
Purpose:
To specify a voltage of the transfer roller (BTR) for optimum printing of each paper type. To lower the
voltage, specify a negative value. To increase, specify a positive value.
The default settings may not yield the best output on all paper types. If you see mottles on the print
output, try increasing the voltage. If you see white spots on the print output, try decreasing the voltage.
Note:
The print quality depends on the values you select for this menu item.
AL-MX200 Series User’s Guide
Using the Operator Panel Menus and Keypad 297
To Next Page
Loading...
