Epson WorkForce AL-MX200DNF - Page 310

Margin Top/Bottom
Purpose:
To specify the value of the top and bottom margins.
Values:
4mm
*
/0.2inch
*
Specify the value in increments of 1 mm/0.1 inch. Which factory default menu
setting displays depends on the value selected for mm / inch under the System
Settings menu. See “mm / inch” on page 296 for more information.
0 - 50mm/0.0 - 2.0inch
*
Factory default menu setting
Margin Left/Right
Purpose:
To specify the value of the left and right margins.
Values:
4mm
*
/0.2inch
*
Specify the value in increments of 1 mm/0.1 inch. Which factory default menu
setting displays depends on the value selected for mm / inch under the System
Settings menu. See “mm / inch” on page 296 for more information.
0 - 50mm/0.0 - 2.0inch
*
Factory default menu setting
Margin Middle
Purpose:
To specify the value of the middle margin.
Values:
0mm
*
/0.0inch
*
Specify the value in increments of 1 mm/0.1 inch. Which factory default menu
setting displays depends on the value selected for mm / inch under the System
Settings menu. See “mm / inch” on page 296 for more information.
0 - 50mm/0.0 - 2.0inch
*
Factory default menu setting
Paper Error
Purpose:
To specify whether to display an error when the specified output paper size does not match the loaded
paper.
AL-MX200 Series User’s Guide
Using the Operator Panel Menus and Keypad 310