To Next Page

To Previous Page

154 Eos Family Operations Manual

To change the setting for any of these fields, press the field in the CIA to activate it. If the field

requires data, enter it from the keypad. If the field is a toggle state, one press of the button will

switch the field to its other state.

{Auto-Mark}

This toggles the AutoMark settings between enabled/ disabled (see AutoMark(on page216) for

more information). AutoMark is “Disabled” by default.

{Mark Time}

This field allows you to set the time that mark instructions will use. When {Mark Time} is disabled,

which is the default, mark instructions will use cue timing unless overridden with discrete timing.

When you enter a mark time in setup, all NPs that mark (either through referenced marking or

AutoMark) will use this time. The only way to override setup mark time is to use discrete timing.

Clearing the {Mark Time} field sets it back to disabled. Select {MarkTime} and hit [Enter] to disable the

default mark time.

{Preheat Time}

If this option is disabled, the cue’s up intensity time will be used when preheating. The default setting

is “Disabled”.

Cue Default Times

This area allows you to set the default cue times for the parameter categories of your system. To

change a time, touch the parameter category button in the CIA and enter the desired time on the

keypad. To set a time for all categories at once, press {Selection Button} [Thru]. Pressing [At] selects

manual times.

The categories for which you may set default times are:

Intensity Up

Intensity Down

Color

Focus

Beam

Show Control Setup

This section allows you to adjust settings for MIDI show control, time code (MIDI or SMPTE), analog,

and serial functions. For more information on using show control with your system, see About Eos

FamilyShow Control(on page494)

Smpte

{SMPTE Time Code Rx}

This button is used to control whether your console can receive SMPTE time code. Choosing “Dis-

abled” will disable all time code lists that have a SMPTE source. The default for this setting is

“Enabled”.

ETC Element 2 Operating Manual

Other manuals for ETC Element 2