To Next Page

To Previous Page

220 Eos Family Operations Manual

Note: {Emergency Mark} can be used to automatically set a mark flag if you had not pre-

viously done so. If using {Earliest M} and no cue with a mark flag has already been set, {Emer-

gency Mark} will set a mark flag. See Record Defaults (on page159)for more information.

Mark Symbols

The symbols that appear in the Mark flag column of the PlaybackStatus Display and the Cue List

Index include:

Live

MK - Indicates the channel is marked for a later cue. The cue number is indicated in the other

categories (see “Q” below).

Q - Found in the non-intensity categories of a marked channel. The “Q” is followed by a num-

ber indicating which cue the mark is in preparation for.

M - Indicates a mark is placed, but manual, and must be stored. Is blue when stored.”m” indic-

ates cue is not marking.

Playback Status Display

D - AutoMark is disabled.

M or m - Indicates a marked cue. “M” indicates an AutoMark or a reference mark that is used

by a subsequent cue. “m” indicates a reference mark that is currently unused by any sub-

sequent cue. Found in the “Flags” area.

R - Indicates the source cue which refers back to an earlier mark. Found in the cue display

“Flags” area.

+ - Indicates a cue is both a marking and reference cue when displayed in the mark flag.

- - Indicates a dark move, a cue that has any non-intensity parameters moving on channels

whose intensity is at 0.

x - Indicates that a mark has been placed, but the mark has been broken. If possible, Eos will

AutoMark the lights.

mh - Indicates that a cue has been flagged as high priority mark, but nothing is marking to it

yet.

Mh - Cue has been flagged as high priority, and lights are marking to it.

ml - Indicates that a cue has been flagged as low priority mark, but nothing is marking to it yet.

Ml- Cue has been flagged as high priority, and lights are marking to it.

Reference Marks and Timing

Movement of non-intensity parameters in conjunction with a mark will adhere to the following tim-

ing rules.

If discretetiming is used for non-intensityparameters:

When channels execute a mark, the moves will use the discrete time(s) assigned to them in the

source cue.

For Example:

A mark is applied to Cue 5, making it the marked cue.

ETC Element 2 Operating Manual

Other manuals for ETC Element 2