EasyManuals Logo

ETC Element 2 Operating Manual

ETC Element 2
649 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #480 background imageLoading...
Page #480 background image
478 Eos Family Operations Manual
Console Port 1 Port 2
Element 10.101.97.101 NA
Element 2 10.101.99.101 192.168.99.101
If DHCP is enabled, this field will display the gateway IP address that is being used by the desk
(whether it is served via DHCP or a self-generated link-local IP address).
Physical Address
The physical address is the MAC address. This address is a unique identifier and cannot be modified.
Enable Remote Startup/ Shutdown
It is possible to remotely power on and off some devices, such as RVIs, RPUs, and client desks.
Note: Eos desks cannot be remotely powered on.
{RemoteStartup} and {RemoteShutdown} must be enabled on each device before it can receive the
power on and off commands. The default setting for both is Disabled.
The Remote Power commands are sent from the browser. The command for Power On is sent from
Browser>Network>Power On MultiConsoleSystem, and the command for Power Off is from
Browser>Network>Power Off MultiConsole System.
Note: Only devices that synchronize with the Primary will be available for Remote Power
On and Off.
Network Interface Delay
When {Required} is enabled, the console will wait for the network connection to be fully initialized
before launching the Eos application.
Note: This option is not available on ETCnomad.
When enabled, a launching window will display on start-up. If a network connection is not made,
you will have the option to {Start Anyway}, {Start Offline}, or to {Cancel}.

Table of Contents

Other manuals for ETC Element 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ETC Element 2 and is the answer not in the manual?

ETC Element 2 Specifications

General IconGeneral
DMX Outputs2
TouchscreenYes
NetworkingEthernet
TypeLighting Control Console
Master Faders2
Encoders4
Ethernet Ports2
USB Ports4
Video OutputDisplayPort
Power Input100-240VAC, 50/60Hz
Power SupplyInternal
Control Channels6144
OutputArt-Net
DisplayMulti-Touch LCD
StorageSolid State Drive (SSD)

Related product manuals