Programming manual.
CNC 8070
·17·
(REF: 1709)
Ref. 0606
Ref. 0608
Ref. 0704 / Ref. 0706
Ref. 0707
Ref. 0709
Ref. 0712
The instruction #EXEC does not issue an error if the channel is busy; the
instruction waits for the operation in progress to end.
• #EXEC instruction.
The instruction #EXBLK does not issue an error if the channel is busy; the
instruction waits for the operation in progress to end.
• #EXBLK instruction.
Software V03.10
Feedrate. Maximum machining feedrate. • Machine parameter: MAXFEED.
Feedrate. Default machining feedrate when none has been programmed. • Machine parameter: DEFAULTFEED.
The CNC allows changing the spindle override during electronic threading
(G33) and in the threading canned cycles of the ·T· model (G86, G87 and their
equivalent of the cycle editor).
• Machine parameters:
THREADOVR, OVRFILTER.
"Retrace" function.
Tangential control.
The CNC checks whether the programmed turning direction (M3/M4) matches
the one preset in the tool table.
M02/M30. There is no need to program M02 or M30 to end a part program. • Functions M02/M30.
Canceling the preset turning direction of a tool. • Variables: (V.)G.SPDLTURDIR
Change the maximum feedrate allowed in the channel from the PLC. • Variables: (V.)PLC.PLCG00FEED
Show the status of the emergency relay. • Variables: (V.)G.ERELAYST
HSC. New FAST mode. • #HSC instruction.
C axis. The #CYL instruction requires programming the radius. • #CYL instruction.
Software V03.11
"Retrace" function. Several improvements to the retrace function.
HSC. New command CORNER. • #HSC instruction.
G33. The override limitation is maintained while returning to the beginning of
the thread.
• Function G33.
RTCP. Home search is now possible on the axes that are not involved in RTCP.
Abort the execution of the program and resume it somewhere else. • Instruction: #ABORT.
Software V03.13
Define the tool wear with incremental or absolute values.
Variables (V.)TM.TOOLCH1[mz] / (V.)TM.TOOLCH2[mz] may be written from
the PLC.
• Variables: (V.)TM.TOOLCH1[mz]
(V.)TM.TOOLCH2[mz].
Software V03.14
MCU and ICU central unit. battery powered RAM. Connecting handwheels to
the central unit. local I/O. Local feedback inputs. Loca probes.
The turning speed limitation (G192) is also applied when the spindle is working
at constant turning speed (G97)
• Function G192.
Software V03.15
Know the type of hardware. • Variable: (V.)G.HARDTYPE
Theoretical tool feedrate along the path • Variable: (V.)G.PATHFEED
Zero offsets for the C axis.
The CNC shows a warning when a channel is expecting a tool that is being
used in another channel.
Software V03.16
Tandem spindles.
The CNC does not assume any kinematics on power-up.
The CNC allows modifying the override while threading if it detects that the
feed forward (parameter FFWTYPE) is not active in a gear or if the active feed
forward is lower than 90%
Software V03.17
C axis maintained after executing M02, M30 or after an emergency or reset. • Machine parameter: PERCAX.
Software V03.01
To Next Page
Loading...
