Programming manual.
CNC 8070
GEOMETRY ASSISTANCE
11.
Work zones.
·223·
(REF: 1709)
If there are 2 circular or rectangular no-exit zones one inside the other, the CNC will only
take into account the outside one. The entire shaded area is the permitted zone.
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
Function G122 is modal. On power-up, after executing an M02 or M30, and after a reset,
the CNC keeps active the zones that were active.
G122 K1 E2
G122 K2 E2
To Next Page
Loading...
