Programming manual.
CNC 8070
13.
TOOL COMPENSATION
·240·
(REF: 1709)
Compensation values
The compensation values applied in each case is calculated from the tool dimensions.
• In tool radius compensation, the applied value is the sum of the radius and radius wear
of the selected tool.
• In tool length compensation, the applied value is the sum of the length and length wear
of the selected tool.
The tool "T" and the tool offset "D", containing the tool dimensions, may be selected
anywhere in the program, even while tool compensation is active. If no tool offset is selected,
the CNC assumes tool offset "D1".
To Next Page
Loading...
