Programming manual.
CNC 8070
13.
TOOL COMPENSATION
Tool radius compensation
·254·
(REF: 1709)
ARC-TO-ARC PATH
When the angle between the tangents of the arcs is smaller than or equal to 180º, the
transition between the paths is independent from the selected G136/G137 function.
When the angle between the tangents of the arcs is greater than 180º, the way the
compensated paths are joined depends on the type of transition selected (G136/G137).
0º < < 90º = 90º
90º <
< 180º = 180º
G136 G137
180º <
< 270º 180º < < 270º
= 270º = 270º
270º <
< 360º 270º < < 360º
To Next Page
Loading...
