Programming manual.
CNC 8070
TANGENTIAL CONTROL.
18.
Turning tangential control on and off.
·315·
(REF: 1709)
Cancel tangential control.
Tangential control is canceled with function G45 or with the instruction #TANGCTRL.
Programming format (1).
This function cancels tangential control in all the axes of the channel.
G45
Programming format (2).
This instruction cancels tangential control in one or several axes. If no axis is programmed,
it cancels tangential control in all the axes of the channel.
The programming format is: Optional parameters are indicated between angle brackets.
#TANGCTRL OFF <[X~C]>
Cancellation of tangential control during tool radius compensation.
Tangential control may be canceled even if tool radius compensation is active. However, it
is recommended to freeze tangential control instead of canceling it. This is because the
instruction #TANGCTRL OFF, besides canceling tangential control, it generates some
additional blocks at the beginning and end of the tool compensation.
G45
X~C Optional. Axis where tangential control is canceled.
#TANGCTRL OFF
#TANGCTRL OFF [A]
#TANGCTRL OFF [B, W, V]
To Next Page
Loading...
