89
18-4-2. Video Level Clip
To maintain the desired signal level after adjusting the video levels with the Proc Amp, use
the Video Level Clip function to adjust the upper and lower limits of YPbPr color space. Note
that the Video Level Clip can be applied only when the Proc Amp is enabled.
(1) Open the [SETUP-INPUT-PROC AMP] menu. (See section
18-4-1. "Proc Amp.")
(2) Turn F1 to select an input signal to be corrected.
INPUT :SELECT : Y-Lv :BLK-Lv :ENABLE : 1/3
PROC AMP: =IN04 : =1.00 : =0 : =ON :
(3) Press the PAGE DOWN button twice to go to PAGE 3.
(4) You can adjust the luminance level under the Y-Lv item, the black level under the BLK-Lv
item and the chrominance level under the Pb-Lv item and the Pr-Lv item.
INPUT :Y-Lv :Blk-Lv : Pb-Lv : Pr-Lv : 3/3
CLIP : =1019 : =4 : =500 : =500 :
To Next Page
