71
13. Still Store
The switcher can capture and memorize up to 2 still pictures from the switcher output video.
Captured stills can then be used as signals for key source, key insertion, PGM select, PST select or
AUX bus select (See section
6-2. "How to Assign Sources to Bus buttons" for assigning stills.).
Although the stored stills are cleared when the switcher is powered down, they can be backed up
within the switcher. Stored stills can also saved to the USB flash memory.
13-1. How to Save Stills
(1) Setup the image for program, preview or AUX output to be captured to STILL1 or 2.
(2) Press MENU, and then 7/SETUP in the MENU/DIRECT PATT/EVENT/KEYPAD block to
display the [STILL STORE] menu
STILL :SIGNAL :STILL1 :STILL2 : : 1/2
STORE : =PGM : >FRAME: >ODD : :
(3) Turn F1 to select the output you wish to capture the still at the SIGNAL item in the menu.
Available settings are PGM, PREV, CLN, AUX1-AUX3. (See section 7. "Video Outputs" for
details about these signals.)
(4) To save the image to STILL1, turn F2 to select the capture type from FRAME, ODD (odd
field) and EVEN (even field), then press F2. A beep sound will be heard and the still image
will be stored to STILL1.
To save the image to STILL2, turn F3 to select the capture type, then press F3. A beep sound
will be heard and the still image will be stored to STILL2.
13-2. Backing-up Stills
To Save Still Images:
(1) Press MENU, and then 8/STILL in the MENU/DIRECT PATT/EVENT/KEYPAD block to
display the [STILL STORE] menu
(2) Press PAGE DOWN to go to PAGE 2 ([STILL RESUME] menu).
(3) Turn F1 to change the RESUME item from OFF to ON. Press F2 to save the image(s) to the
backup memory. The saved images will remain after turning off the switcher.
STILL :RESUME : SAVE : LOAD : : 2/2
RESUME : =ON : =STIL1: =STIL1: :
To Load Saved Images to Still Memory Manually:
(1) Open the [STILL RESUME] menu.
(2) Turn F3 to select the image(s) you wish to load between STIL1 and STIL2. Press F3 to load
the image to the still store memory.
STILL :RESUME : SAVE : LOAD : : 2/2
RESUME : =ON : =STIL1: =STIL1: :
To Load Saved Images to Still Memory Automatically:
The still images are automatically loaded at startup following the LOAD setting in the [STILL
RESUME] menu when the RESUME item is set to ON.
To Next Page
Loading...
