3
2-2. HVS-300RPS (Power Redundant Model)
Front Panel
No. Name Description
1 Power switch1 For Power1 ON/OFF.
2 Power switch2 For Power2 ON/OFF.
2
POWER
indicator
Lit green Power is supplied to the unit.
Unlit Power is supplied to the unit.
ALARM
indicator
Lit red when a power or a cooling fan fails. In such a case, power off
the unit and consult your FOR-A supplier. The indicator is normally
unlit.
* This indicator works the same as the ALARM indicator located on
the Control panel.
Rear Panel
No. Name Description Refer to
1 SDI INPUT Used to input HD/SD SDI video signal. 4 inputs (BNC) 6
2 SDI OUTPUT
Used to output HD/SD SDI video signal. 4 outputs (2
programs and 2 auxiliary outputs) (BNC)
7
3
GPI IN/
TALLY OUT
Used for GPI input/output and Tally output. (15-pin D-sub,
female)
2-5-3
4 RS-422
Used to connect HVS-30RU and Hanabi tally units.
(9-pin D-sub, female)
2-5-2
5 LAN Used for 10BASE-T Ethernet connection. (RJ-45)
6 EDITOR Used for editor connection. (9-pin D-sub, female) 2-5-1
7 GENLOCK
Used to input/output a genlock signal; tri-level sync or
black burst. (BNC)
The center terminal is used for loopthrough connection. It
must be 75-ohm terminated if not looped-through.
18-2
8 TO OU
Used for HVS-30OU connection via Arcnet. It can be also
used to connect the Hanabi AUX control boxes. (BNC)
One of two terminals is used for loopthrough connection.
It must be 75-ohm terminated if not looped-through.
3-1
9 Option Slots Used to install optional input/output expansion cards. 2-4
10 AC IN1
Used for AC power connection via supplied cable.
(AC100V-240V 50/60Hz)
11 AC IN2
Used for AC power connection via supplied cable.
(AC100V-240V 50/60Hz)
12 Ground terminal Used for system grounding.
ON
POWER 2
OFF
POWER 1 ALAR M
ON
POWER 1
OFF
POWER 2
HVS-300RPS
DIGITAL VIDEO SWITCHER
EDITOR
LAN
(10/10 0BAS E-T)
RS-422
GPI IN/TALLY OUT
REF OUTREF IN
GENL OCK
AUX 2AUX 1PGM 2PGM 1
SDI OUTPUT
4321
SDI INPUT
AC100-240V 50/60Hz IN21
OPTION SLOT DOPTION SLOT COPTION SLOT A OPTION SLOT B
RATING LABEL
TO OU
To Next Page
