49
When switching to DIRECT PATT mode, the number buttons onto which patterns are
already saved light up. If a user presses one of them to save a selected pattern, the
number button blinks. To overwrite the pattern, press the number button again.
If users cannot overwrite the number buttons, change the OVER Wr (overwrite) item from
DISBL (disabled) to ENABL (enable) in the [DIRECT RECALL] menu. The [DIRECT
RECALL] menu is automatically displayed when the RECALL button is pressed on the
KEYPAD.
To Select a Pattern using the RECALL button:
(1) Press the DIRECT PATT button to the right of the Menu Display.
(2) Press the number button where the desired pattern has been saved.
(3) Press the RECALL button. The transition type is automatically switched to WIPE and the
current pattern is changed to the new one.
To Select a Pattern without RECALL button (Setting required. See below.):
(1) Press the DIRECT PATT button to the right of the Menu Display.
(2) Press the number button where the desired pattern has been saved. The transition type is
automatically switched to WIPE and the current pattern is changed to the new one.
To perform quick pattern selections without pressing RECALL, switch DIRECT on in the
[DIRECT PATTERN] menu. The [DIRECT PATTERN] menu is automatically displayed
when pressing DIRECT PATT.
To Clear a Direct Pattern Registration Individually
(1) Press the DIRECT PATT button to display the [DIRECT PATT] menu.
(2) Turn F1 to change DIRECT to OFF, if it is ON.
DIRECT :DIRECT :CLEAR : : : 1/1
PATTERN: =OFF : =ALL : : :
(3) Press the number button to be cleared. The [DIRECT RECALL] menu will then be
displayed.
(4) Turn F4 to change DELETE to ON. Press F4 to delete the registration.
DIRECT : NO.20 :OVER WR:DELETE : 1/1
STORE : : =ON : >OFF :
NOTE
Before clearing a direct pattern registration, set the DIRECT item to OFF. Otherwise,
the selected pattern is applied the panel when pressing the number button.
To Clear All Direct Pattern Registrations
(1) Press the DIRECT PATT button to display the [DIRECT PATT] menu.
(2) Turn F2 to set CLEAR to ON. Press F2 to clear all direct pattern registrations.
DIRECT :DIRECT :CLEAR : : : 1/1
PATTERN: =OFF : >ON : : :
To Next Page
Loading...
