FortiGate Version 3.0 MR4 Administration Guide
114 01-30004-0203-20070102
Configuring DHCP services System DHCP
Configuring DHCP services
Go to System > DHCP > Service to configure DHCP services. On each FortiGate
interface, you can configure a DHCP relay and add DHCP servers as needed.
On FortiGate models 50 and 60, a DHCP server is configured, by default, on the
Internal interface, as follows:
You can disable or change this default DHCP Server configuration.
These settings are appropriate for the default Internal interface IP address of
192.168.1.99. If you change this address to a different network, you need to
change the DHCP server settings to match.
Figure 58: DHCP service list - FortiGate-200A shown
IP Range 192.168.1.110 to 192.168.1.210
Netmask 255.255.255.0
Default gateway 192.168.1.99
Lease time 7 days
DNS Server 1 192.168.1.99
Interface List of FortiGate interfaces. Expand each listed interface to view the
Relay and Servers.
Server Name/
Relay IP
Name of FortiGate DHCP server or IP address of DHCP server
accessed by relay.
Type Type of DHCP relay or server: Regular or IPSec.
Enable Green check mark icon indicates that server or relay is enabled.
Add DHCP Server
icon
Configure and add a DHCP server for this interface.
Edit Edit DHCP relay or server configuration.
Delete Delete a DHCP server.
Add DHCP Server
Edit
Delete
To Next Page
Loading...
