EasyManuals Logo

Fortinet Fortigate-5000 series User Manual

Fortinet Fortigate-5000 series
458 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
FortiGate Version 3.0 MR4 Administration Guide
78 01-30004-0203-20070102
Interface System Network
5 In the Wireless Settings section, enter the following information:
Figure 31: Wireless interface settings
6 Configure other interface options as required.
7 Select OK.
Configuring DHCP on an interface
If you configure an interface to use DHCP, the FortiGate unit automatically
broadcasts a DHCP request. The interface is configured with the IP address and
optionally DNS server addresses and default gateway address that the DHCP
server provides.
Go to System > Network > Interface. Select Create New or select the Edit icon
of an existing interface. In the Addressing mode section, select DHCP.
SSID Enter the wireless network name that the FortiWiFi-60 unit
broadcasts. Users who want to use the wireless network
must configure their computers to connect to the network
that broadcasts this network name.
SSID Broadcast Select if you want the unit to broadcast its SSID. (Access
Point mode only)
Security Mode To use WEP, select WEP64 or WEP128. To use WPA
(available in Access Point mode only), select WPA Pre-
shared Key or WPA_Radius. Users of the FortiWiFi-60
wireless network must configure their computers with the
same settings.
Key For a 64-bit WEP key, enter 10 hexadecimal digits (0-9 a-
f). For a 128-bit WEP key, enter 26 hexadecimal digits (0-9
a-f). Users of the wireless network must configure their
computers with the same key.
Pre-shared Key For WPA Pre-shared Key security mode, enter the pre-
shared key. Users of the wireless network should
configure their computers with the same key.
RADIUS Server Name For WPA Radius security mode, choose the Radius server
name from the list. The Radius server must be configured
in User > Radius. For more information, see “RADIUS
servers” on page 322.
Data Encryption This applies to WPA mode. Select either TKIP or AES
(WPA2) data encryption.
RTS Threshold The Request to Send (RTS) threshold sets the time the
unit waits for Clear to Send (CTS) acknowledgement from
another wireless device.
Fragmentation Threshold Set the maximum size of a data packet before it is broken
into two or more packets. Reducing the threshold can
improve performance in environments that have high
interference.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet Fortigate-5000 series and is the answer not in the manual?

Fortinet Fortigate-5000 series Specifications

General IconGeneral
BrandFortinet
ModelFortigate-5000 series
CategoryFirewall
LanguageEnglish

Related product manuals