EasyManuals Logo

Fortinet Fortigate-5000 series User Manual

Fortinet Fortigate-5000 series
458 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #260 background imageLoading...
Page #260 background image
FortiGate Version 3.0 MR4 Administration Guide
260 01-30004-0203-20070102
Configuring virtual IPs Firewall Virtual IP
Adding static NAT port forwarding for a single IP address and a single port
The IP address 192.168.37.4, port 80 on the Internet is mapped to 10.10.10.42,
port 8000 on a private network. Attempts to communicate with 192.168.37.4,
port 80 from the Internet are translated and sent to 10.10.10.42, port 8000 by the
FortiGate unit. The computers on the Internet are unaware of this translation and
see a single computer at 192.168.37.4, port 80 rather than a FortiGate unit with a
private network behind it.
Figure 154:Static NAT virtual IP port forwarding for a single IP address and a single
port example
To add static NAT virtual IP port forwarding for a single IP address and a
single port
1 Go to Firewall > Virtual IP > Virtual IP.
2 Select Create New.
3 Use the following procedure to add a virtual IP that allows users on the Internet to
connect to a web server on the DMZ network. In our example the external
interface of the FortiGate unit is connected to the Internet and the dmz1 interface
is connected to the DMZ network.
Name Port_fwd_NAT_VIP
External Interface external
Type Static NAT
External IP Address/Range The Internet IP address of the web server.
The external IP address must be a static IP address obtained
from your ISP for your web server. This address must be a
unique IP address that is not used by another host and
cannot be the same as the IP address of the external
interface the virtual IP will be using. However, the external IP
address must be routed to the selected interface. The virtual
IP address and the external IP address can be on different
subnets. When you add the virtual IP, the external interface
responds to ARP requests for the external IP address.
Map to IP/IP Range The IP address of the server on the internal network. Since
there is only one IP address, leave the second field blank.
Port Forwarding Selected
Protocol TCP
External Service Port The port traffic from the Internet will use. For a web server,
this will typically be port 80.
Map Port The port on which the server expects traffic. Since there is
only one port, leave the second field blank.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortinet Fortigate-5000 series and is the answer not in the manual?

Fortinet Fortigate-5000 series Specifications

General IconGeneral
BrandFortinet
ModelFortigate-5000 series
CategoryFirewall
LanguageEnglish

Related product manuals