Router Dynamic RIP
FortiGate Version 3.0 MR4 Administration Guide
01-30004-0203-20070102 191
Figure 105:Basic RIP settings
RIP Version Select the level of RIP compatibility needed at the FortiGate unit. You can
enable global RIP settings on all FortiGate interfaces connected to RIP-
enabled networks:
• Select 1 to send and receive RIP version 1 packets.
• Select 2 to send and receive RIP version 2 packets.
You can override the global settings for a specific FortiGate interface if
required (see “Overriding the RIP operating parameters on an interface” on
page 193).
Advanced
Options
Select advanced RIP options. See “Selecting advanced RIP options” on
page 192.
Networks The IP addresses and network masks of major networks (connected to the
FortiGate unit) that run RIP. When you add a network to the Networks list,
the FortiGate interfaces that are part of the network are advertised in RIP
updates. You can enable RIP on all FortiGate interfaces whose IP
addresses match the RIP network address space.
IP/Netmask Enter the IP address and netmask that defines the RIP-
enabled network.
Add Select to add the network information to the Networks
list.
Interfaces Any additional settings needed to adjust RIP operation on a FortiGate
interface.
Create New Select to configure RIP operating parameters for an
interface. These parameters will override the global RIP
settings for that interface. See “Overriding the RIP
operating parameters on an interface” on page 193.
Interface Select the interface to configure RIP operating
parameters for.
Send Version Select the version of RIP used to send updates through
each interface: 1, 2, or both.
Receive Version Select the versions of RIP used to listen for updates on
each interface: 1, 2, or both.
Authentication Select the type of authentication used on this interface:
None, Text or MD5.
Passive Select to block RIP broadcasts on this interface
Delete and
Edit icons
Delete or edit a RIP network entry or a RIP interface definition.
Edit
Delete
Delete
To Next Page
Loading...
Need help?
General