Fortinet Fortigate-5000 series - Page 244

FortiGate Version 3.0 MR4 Administration Guide
244 01-30004-0203-20070102
Configuring custom services Firewall Service
To add a custom ICMP service
1 Go to Firewall > Service > Custom.
2 Set Protocol Type to ICMP.
3 Configure the following.
Figure 138:New Custom Service - ICMP
To add a custom IP service
1 Go to Firewall > Service > Custom.
2 Set Protocol Type to IP.
3 Configure the following.
Figure 139:New Custom Service - IP
Name Enter a name for the custom service.
Protocol Type Select the protocol type of the custom service: TCP/UDP.
Protocol Select TCP or UDP as the protocol of the port range being added.
Source Port Specify the Source Port number range for the service by entering the
low and high port numbers. If the service uses one port number, enter
this number in both the low and high fields. The default values allow the
use of any source port.
Destination Port Specify the Destination Port number range for the service by entering
the low and high port numbers. If the service uses one port number,
enter this number in both the low and high fields.
Add If the custom service being created requires more than one port range,
select Add to allow more source and destination ranges.
Delete Icon Select to remove the entry from the list.
Name Enter the name of the ICMP custom service.
Protocol Type Select the protocol type of the service being added: ICMP.
Type Enter the ICMP type number for the service.
Code Enter the ICMP code number for the service if required.
Name Enter the name of the IP custom service.
Protocol Type Select the protocol type of the service being added: IP.
Protocol Number The IP protocol number for the service.