Fuji Xerox ApeosPort-3 C4400

3 Copy
120
Copy
3
Cancel
The remaining copies are cancelled.
Start
The remaining copies are made.
Note • The same operation is performed if you press the <Start> button on the control panel.
Combine Original Sets (Adding Originals)
Use this feature when you copy a document that has too many pages to be loaded into
the document feeder at one time, or when you scan each document page using the
document glass and have the machine process the pages as one job.
[Next Original] that is usually displayed while scanning documents with the document
feeder is always selected in this mode. In addition, when using the document glass to
scan documents, [Next Original] is also selected during scanning. If [Copy Output] is
set to [Auto], the output is automatically sorted.
When all documents have been scanned, select [Last Original].
Note • After the first original set is copied, the screen will automatically return to the previous
display if the machine is left unused for the period specified under [Auto Clear]. For details
on [Auto Job Release], refer to "5 Tools" > "Common Service Settings" > "Machine Clock/
Timers" > "Auto Job Release" in the Administrator Guide.
1 Select [Combine Original Sets].
2 Select [On].
Off
Disables this feature.
On
Enables this feature.
Original Orientation
Allows you to specify the orientation of the document to have the machine identify the
top of the document.
Note • If the [Original Orientation] differs from the actual document orientation, then the machine
may mistakenly detect the top of the document.
z
Upright Images
Select this item when placing the top edge of the document against the top side of
the document glass or document feeder.
z
Sideways Images
Select this item when placing the top edge of the document against the left side of
the document glass or document feeder.