Fuji Xerox ApeosPort-3 C4400

Operations during Faxing
133
Fax
4
If the screen shown in Step 2 does not appear even after you press the <Stop>
button on the control panel:
1 Press the <Job Status> button.
2 Select the job to cancel, and then select
[Cancel].
Changing the Scan Settings
You can change the scan settings while scanning the document.
1 Select [Next Original].
2 Set [Resolution], [Original Size], and
[Lighten/Darken].
For each setting, refer to "Resolution (Specifying the
Scanning Resolution)" (P.151), "Original Size
(Specifying the Scan Size for the Original)" (P.153),
or "Lighten/Darken (Adjusting Fax Density)" (P.149).
3 Press the <Start> button.
123
456
789
0#
C
<Job Status> button