Scan to PC
211
Scan
5
Scan to PC
You can convert scanned data to TIFF, JPEG, PDF, DocuWorks, or XPS format, and
then use the FTP or SMB protocol to send the data to a computer on the network. The
following shows the reference section for each feature.
Transfer Protocol...................................................................................................................... 211
Address Book (Specifying a Destination PC Using the Address Book).................................. 212
Browse... (Specifying a Destination PC by Browsing Your Network).................................... 212
Specifying a Destination (Specifying a Destination PC Using the Screen Keyboard) ............ 213
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• Before scanning, a shared folder must be created on the computer for saving scanned data.
If the FTP protocol is used, the FTP service must be set. For information on the computer
settings, refer to the documentation supplied with your operating system. For information on
compatible operating systems, refer to "15 Appendix" > "Specifications" > "Scan Function" in
the Administrator Guide.
1
Select [Scan to PC] from the [All Services]
screen.
2
Specify a forwarding destination on the
[Scan to PC] screen.
Note • Fields displayed vary depending on the
protocol.
Transfer Protocol
You can select a transfer protocol using the following procedure.
1
Select [Transfer Protocol].
2
Select any item.
îš„FTP
Transfers using the FTP protocol.
îš„SMB
Transfers using the SMB protocol.
îš„SMB (UNC Format)
Transfers using the SMB protocol (UNC Format).
UNC stands for Universal Naming Convention and its format is as follows:
\\host name\shared name\directory name
To Next Page
Loading...
Need help?
General
