8 Stored Programming
264
Stored Programming
8
4
Select the feature.
îš„Store
Register a stored program.
Refer to "Registering Stored Programs" (P.264).
îš„Store Build Job
Register a stored program for Build Job.
Refer to "Registering Stored Programs for Build Job" (P.265).
îš„Delete
Deletes a stored program.
Refer to "Deleting Stored Programs" (P.266).
îš„Enter/Change Name
Enter or change a stored program name.
Refer to "Entering/Changing a Stored Program Name" (P.266).
îš„Assign/Change Icon
Configure an icon for a registered stored program.
Refer to "Assigning/Changing Icons for Stored Programs" (P.267).
Registering Stored Programs
Up to 100 actions can be registered with one stored program. Up to 40 stored programs
can be registered in the machine.
Actions registered in stored programs No.1 to 20 can also be performed by using one
touch buttons <M01> to <M20>. (This feature is available only when the optional Fax
service is installed).
The following is the procedure for registering actions with stored programs.
Important • If registered settings such as tray paper size and comments, or default values in the system
settings are changed after a stored program is registered, then the program's content also
changes.
Note • Services using System Settings, Job Flow Sheet, Network Scanning, or Address Book
cannot be registered.
• The registering procedure for a stored program is cancelled when the <Interrupt> button is
pressed, the Auto Clear feature causes a time-out, or a popup window (paper jam, etc.)
appears.
To Next Page
Loading...
Need help?
General
