Fax
4
4 Fax
130
For information on specifying a fax number using the address book, refer to "Specifying a Destination
Using the Address Book" (P.145).
For information on specifying a fax number using the speed dialing, refer to "Speed Dialing (Specifying
a Destination Using an Address Number)" (P.146).
For information on specifying a fax number using one touch buttons, refer to "Specifying a Destination
using a One Touch Button" (P.147).
For information on the Internet Fax, refer to "About Internet Fax" (P.134).
Step 4 Starting the Fax Job
The following explains the procedure to start a fax job.
1
Press the <Start> button.
Important • If the document has been set in the
document feeder, do not hold down the
document while it is being conveyed.
• Fax cannot be sent if a copy protection
code is detected.
Note • Depending on the settings, the screen to
re-enter the recipient may be displayed
after pressing the <Start> button. In this
case, re-enter the recipient.
• If a problem occurs, an error message
appears in the touch screen. Solve the
problem in accordance with the message.
• You can set the next job during faxing.
If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set
of data.
2
While documents are being scanned, select
[Next Original].
Note • When using the document feeder, load
the next document after the machine has
finished scanning the first document.
• When the above screen is displayed and
no operation is performed for a certain
period of time, the machine automatically
assumes that there are no more documents.
• You can change the scan settings of the next document by selecting [Resolution], [Scan
Size] and [Lighten/Darken] displayed after selecting [Next Original].
3
Load the next document.
123
456
789
0#
C
<Start> button
To Next Page
Loading...
