Fuji Xerox ApeosPort-3 C4400

3 Copy
62
Copy
3
2 Select [Change Quantity...].
3 Set the number of copy sets with the numeric keypad. The new quantity must include
the number of copies that have already been printed. You cannot enter a number less
than the number of copies that have already been printed.
4 Press the <Start> button.
Note • If you enter the same value as the number of copies that have already been printed, the
machine will not execute a copy job even when you press the <Start> button.
Interrupting the Copy Job
You can temporarily stop the copy job to have the machine process another job.
Important • Press the <Interrupt> button only after all the documents have been scanned. The machine
does not accept another job while it is scanning the documents, or [Next Original] is being
selected.
1 Press the <Interrupt> button.
Note • The interrupt indicator lights up to indicate
that the machine is in the interrupt mode.
2 Load a document and set features if necessary.
3 Set the number of copy sets with the numeric keypad.
4 Press the <Start> button.
5 After you have finished making the interrupt copy, press the <Interrupt> button.
Note • The interrupt indicator goes out to indicate that the interrupt mode is exited.
• If you used the document glass to copy the document, remove the document from the
document glass.
6 Press the <Start> button. The suspended copy job is resumed.
123
456
789
0#
C
<Interrupt> button