Job Assembly
121
Copy
3
[Copy Job] screen
The [Copy Job] screen is displayed when copying begins.
îš„Cancel
The document data stored by [Combine Original Sets] is cleared and the copying is
cancelled.
Note • The same operation is performed if you press the <C> button or <Clear All> button on the
control panel.
îš„Last Original
Select this to end scanning documents.
îš„Next Original
Select this when you have more documents to copy. This button is activated when the
[Combine Original Sets] feature is used.
îš„Start
Load the next document, and select [Start] to start scanning.
Note • The same operation is performed if you press the <Start> button on the control panel.
Delete Outside/Delete Inside
(Deleting Outside or Inside of the Selected Area)
This feature allows you specify the area to be deleted from a document image. 3 areas
can be specified.
1
Select [Delete Outside/Delete Inside].
2
Select any item.
îš„Off
No area is deleted.
îš„Delete Outside
Deletes the outside of the selected area.
îš„Delete Inside
Deletes the inside of the selected area.
To Next Page
Loading...
Need help?
General
