Job Assembly
115
Copy
3
Job Assembly
On the [Job Assembly] screen, you can configure features such as Build Job and
Sample Set. The following shows the reference section for each feature.
Build Job (Processing Documents Scanned with Different Settings as One Job) ................... 115
Sample Job (Checking the Finished Output of the Copy)........................................................ 119
Combine Original Sets (Adding Originals).............................................................................. 120
Delete Outside/Delete Inside (Deleting Outside or Inside of the Selected Area) .................... 121
Stored Programming (Calling a Stored Program for Build Job).............................................. 123
1
On the [All Services] screen, select [Copy].
2
Select the [Job Assembly] tab, and then
select a feature on the [Job Assembly]
screen.
Build Job (Processing Documents Scanned with Different Settings as
One Job)
This feature allows you to apply different copy settings to each document page or each
document stack, and then outputs the copies as one job.
1
Select [Build Job].
2
Select [On].
3
Select the desired print settings.
Note • Select [ ] to return to the previous
screen or [ ] to move to the next screen.
îš„Build Job Off
Build Job is not applied.
îš„Build Job On
Build Job is applied. The feature buttons appear. Set any item if necessary.
Important • The features set here cannot be canceled or changed while the machine performs a copy
job.
For features available in Build Job, refer to "Features that can be set in Build Job" (P.115).
Features that can be set in Build Job
îš„Copy Output
For information on the feature, refer to "Copy Output (Specifying Finishing Options)" (P.112).
To Next Page
Loading...
Need help?
General
