3 Copy
116
Copy
3
Booklet Creation
For information on the feature, refer to "Booklet Creation (Creating a Booklet)" (P.92).
Covers
Important • The machine does not copy on a cover when using the Build Job feature.
For information on the feature, refer to "Covers (Attaching Covers to Copies)" (P.95).
Annotations
For information on the feature, refer to "Annotations (Adding a Comment / a Date / Page Numbers to
Copies)" (P.101).
Segment Separators
For information on the feature, refer to "[Segment Separators] Screen" (P.117).
Watermark
For information about the feature, refer to "Watermark (Printing Control Numbers on the Background of
Copies)" (P.107).
Secure Watermark
For information about the feature, refer to "Secure Watermark (Managing Document Security)" (P.109).
[Copy Job] screen
The following describes the screen that appears while the Build Job is being executed.
Change Settings...
Displays the [Copy] screen allowing you to change the settings. After changing the
settings as necessary, press the <Start> button on the control panel to start scanning
of the document. If you want to return to the previous screen, press the < # > button.
When using a stored program for Build Job
While the machine makes copies using the Build Job feature, you can use a stored
program.
1) Select [Change Settings...].
2) Select the [Job Assembly] tab.
3) Select [Stored Programming].
4) Select the number of the stored program that contains the features you wish to use.
Note • You can only select numbers that have been registered.
For information on how to register a stored program, refer to "Registering Stored Programs for Build
Job" (P.265).
Chapter Start...
Displays the [Build Job - Chapter Start] screen.
Refer to "[Build Job - Chapter Start] Screen" (P.118).
To Next Page
Loading...
