Fax
4
4 Fax
184
Auto Send (transmitting without picking up the receiver)
1
Select [Keyboard] to display the keyboard on the touch screen and enter in the
following format.
2
Select [+ Add] to perform Multiple Relay Broadcast.
z
Password
A pre-registered two-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support
Center. If a password has not been set, you do not need to enter one.
z
Relay Station ID
The last two digits of the initiating station address number registered at the primary
relay station
z
Address Number
The address number for the secondary relay station registered at the primary relay
station
The above dialing format can be registered in an address number to send using the address number. For
information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
Manual Send (transmitting with picking up the receiver or on-hook)
1
Select the [More Options] tab to display the
[More Options] screen.
2
Pick up the telephone receiver, or select [On-
hook (Manual Send/Receive)].
3
Select [Manual Send] from the drop-down
menu.
4
Use the keyboard shown in the touch screen
to enter numbers in the following format.
Note • You can specify up to 20 locations for relay recipients.
To Next Page
Loading...
