Understanding the Machine Menus
165
Tools
9
Values:
z
Ring Tone Volume
Purpose:
To set the volume of the ring tone, which indicates that an incoming call is a telephone
call through the internal speaker when [Receive Mode] is set to [TEL/FAX Mode].
Values:
z
Auto Answer Setup
Purpose:
To configure settings for automatic fax reception.
Values:
TEL Mode Automatic fax reception is turned off. You can receive a fax by
picking up the handset of the external phone and then pressing
the remote receive code, or by selecting [Manual Receive] in
[OnHook] to [On] (you can hear voice or fax tones from the
remote machine) and then pressing the <Start> button. For more
information on [Manual Receive], refer to "Receiving a Fax
Manually in the TEL Mode" (P.113).
Fax Mode Automatically receives faxes.
TEL/FAX Mode When the machine receives an incoming fax, the external
telephone rings for the time specified in [Auto Answer TEL/FAX],
and then the machine automatically receives a fax. If an incoming
call is not a fax, the machine beeps from the internal speaker
indicating that the call is a telephone call.
Ans/FAX Mode The machine can share a telephone line with an answering
machine. In this mode, the machine will monitor the fax signal
and pick up the line if there are fax tones. If the phone
communication in your region is serial, this mode is not supported.
DRPD Mode Before using the Distinctive Ring Pattern Detection (DRPD) option,
a distinctive ring service must be installed on your telephone line
by the telephone company. After the telephone company has
provided a separate number for faxing with a distinctive ring
pattern, configure the fax setup to monitor for that specific ring
pattern.
Off Turns off the volume of the ring tone.
Min Sets the volume of the ring tone to minimum.
Middle Sets the volume of the ring tone to middle.
Max Sets the volume of the ring tone to maximum.
Auto Answer Fax 0 Sets the interval at which the machine goes
into the fax receive mode after receiving an
incoming call. The value is set in increments
of 1 second.
0-255
Auto Answer TEL/FAX 6 Sets the interval at which the machine goes
into the fax receive mode after the external
telephone receives an incoming call. The
value is set in increments of 1 second.
0-255
To Next Page
Loading...
